Selges: Stort koplett bilstereo anlegg

[knekt]

Alpine V12 MRV-F540

 

» 80 watts RMS x 4 at 4 ohms

» 100 watts RMS x 4 at 2 ohms

» 200 watts RMS x 2 in bridged mode

» 2-, 3-, or 4-channel output

» Tri-way capable (Tri-Way Crossover required)

» requires 8-gauge power and ground leads — wiring and hardware not included with amplifier

» Bass Engine® features front and rear high-pass (variable 15-8,000 Hz)/low-pass (variable 30-8,000 Hz)

crossovers, 12 dB/octave

» MOSFET power supply

» STAR Topology (minimizes internal noise and prevents ground interference)

» preamp outputs

» oversized power and ground connections

» gold-plated screw terminals

» top mounted controls with cover

» detachable front cover

» blue power LED

» 16-1/2"W x 2-1/2"H x 9-7/8"D

 

 

Alpine V12 MRD-M1000 Specifications

Features:

 

General-Amplifiers

* 8.5 Volt Input Capability

* Alpine V12 PWM Power Supply

* Bass Engine® DSP(Parametric EQ, Crossover, Time Correction, Phase Control, Subsonic Filter, Bass Compensator)

* Blue Power Indicator

* Control Panel Cover

* Digital Control Center with LCD Display (Voltage, Current, and Temp Indicator)

* Gold Plated Power Screw Terminals

* Gold Plated Speaker Screw Terminals

* Integrated Wire and Mounting Screw Covers

* RCA PreOutput (L, R)

* Remote Bass Knob or Remote Amplifier Control Center (RACC) Ready

* STAR Topology

* Safe Mode

* Top Mounted Controls

* V12 AccuClass-D™ Design

* Variable Turn-On Delay

 

Specs:

 

Bass Engine®

* Bass Compensation : 3-Level

* Crossover Type : 24dB/Octave Slope - Digital

* Low Pass Crossover Frequency (Selectable) : 30Hz - 200Hz (1/12 oct. Steps)

* Number of Time Correction Channels : 1

* Parametric EQ "Width" (Selectable) : 0.5,1,2,3,4,5 ("Q")

* Parametric EQ Frequency (Selectable) : 30Hz - 160Hz (1/12 Oct. Steps)

* Parametric EQ Level (Selectable) : ±12dB (1dB Steps)

* Subsonic Filter Range : 15Hz - 50Hz (5Hz Steps) or OFF, 24dB/octave Slope

* Subwoofer Level Adjustment Range (With RUX-4180 or RUX-4280 Connected) : -15dB to 0dB (1dB steps)

* Subwoofer Phase Control : Normal (0°) or Reverse (180°)

* Time Correction Adjustment Range : 0 - 10 mSec. (0.1mSec. Steps)

 

General-Amplifiers

* Analog-Digital Conversion : 24Bit/96kHz

* Foot Print (WxHxD)in : 9-3/4" x 2-1/2" x 21-21/32"

* Foot Print (WxHxD)mm : 247mm x 65.84mm x 550mm

* Frequency Reponse : 10Hz-500Hz (+0, -1dB)

* Gain Factor : 0/+6 /+12dB

* Heat Sink w/Cover (WxHxD)in : 11-7.16" x 2-1/2" x 21-1/32"

* Heat Sink w/Cover (WxHxD)mm : 290.5mm x 65.84mm x 550mm

* Input Impedance : 10k ohm

* Input Level : 0dB to -24dB, 1dB Steps

* Input Sensitivity (for rated power) : 0.5V to 8.5V

* Memory : None Volatile, EEPROM

* Pre-amp Output : up to 8.5V RMS, Buffered

* Safe Mode : On/Off (Output Disable)

* Signal to Noise (S/N) : 100dBA (referenced to rated power)

* Speaker Impedance : 4 or 2 ohms (Mono)

* Variable Turn-on Delay : 0-2s, 0.25s Steps

* Weight (Kgs) : 8kgs

* Weight (lbs) : 17.7 lbs

 

MAX Power (at 14.4V,EIAJ)

* Bridged 2 ohms : 1600W x 1 (20-200Hz/1% THD)

 

RMS Power (at 12V,20Hz-200Hz)

* Per channel into 2 ohms : 700W x 1 (1% THD)

* Per channel into 4 ohms : 350W x 1 (1% THD)

 

RMS Power (at 14.4V,20Hz-200Hz)

* Per channel into 2 ohms : 1000W x 1 (1% THD)

* Per channel into 4 ohms : 500W x 1 (1% THD)

 

 

Amega Qcomp 60 - 100w 4ohm

 

Alpine SPX-177A

 

Key Features: 6-3/4" hemp-fiber woofer cast aluminum woofer frame nitrobutylene rubber

(NBR) surround 1" hand-coated textile dome tweeter swivels up to 30 (surface- and flush- mounting)

2-way crossover with extensive adjustment circuitry biamp or single input operation

frequency response 35-35,000 Hz recommended power range 8-60 watts RMS

peak power handling 240 watts sensitivity 90 dB top-mount depth 2-3/4"

 

 

ROCKFORD FOSGATE

HE2 RFP4212 Dual 4-ohm Voice Coil 12" Sub

 

Peak Power Handling 800Watts

RMS Power Range 100-400Watts

Impedance ( Ohms ) 4

Free-Air No

Dual Voice Coil Yes

Sensitivity 86dB

Frequency Response 28-0.2KHz

Cone Material Polypropylene

Surround Material BART Foam

Dimensions

Sealed Box Volume (cu ft 0.9-2.79

Ported Box Volume (cu ft) 1.75-4

Top Mount Depth 6-3/16"

Cutout Diameter or Length 11-1/8"

Size 12"

 

anlegget har vært i bruk i ca 15t....selges pga ikke no bil og ha det i lenger

selges høystbydende.....kom med bud